Knowledgebase: Technical Support > VoIP
How to setup VoIP in the Billion BIPAC7401VGPR3
Posted by Dennis Ganchingco, Last modified by Dennis Ganchingco on 17 November 2010 03:18 PM

How to setup VoIP in the Billion BIPAC7401VGPR3


Follow these steps to configure the VoIP section of your router.

Getting to the VoIP Section


  1. Once you have logged into, at the left side menu click on Advanced.

  2. Click Configuration and a submenu will appear.

  3. Click VoIP which will open up another submenu.


SIP Device Parameters


  1. Click SIP Device Parameters to open up the page.

  2. Make sure for SIP, Enable is selected.

  3. Also Australia is selected for Region.

  4. Then click on the Apply button.


SIP Accounts


  1. Click SIP Accounts from the left menu bar to open up the SIP accounts configuration page.

  2. You can enter anything in the Profile Name.

  3. Enter sip.atu.net.au in Registrar Address(or Hostname), User Domain/Realm and Outbound Proxy Address.

  4. Leave the Registrar Port and Outbound Proxy Port as 5060.

  5. Enter 240 in Expire(seconds).

  6. Then in Phone Number, Username and Display Name enter the username given to you by us.

  7. Enter the password you set for the VoIP prepaid account in the Password field.

  8. Click on the Add button.

  9. Then lastly, click on Save Config from the bottom of the page and click the Apply button.

(263 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk by ATU Internet Pty Ltd